How to add 820/810 series in Genetec

Applies to: 820/810 series

Recommend firmware: NK20150805nsa or up

 

  1. Open the 820/810 webpage and configure the stream setting (1xh264, 2x h264, 1xmjpeg/1xh264 etc)

  2. Add the camera in Genetec with the MDxx/HDxx driver. (see picture)
  3. Configure resolution, quality, bit rate etc in Genetec (not on the 820/810 webpage!)

Important: it's not possible to change video streaming settings on webpage of the 820/810 series when the camera is added in Genetec.
Remove the camera from Genetec when you want to change the video streaming settings.

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments